118L Kegmenter with 4inch Flat Lid , Airlock and 2inch end cap

Using the 2" TC Port 3600W Heating Element
This oversized kegmenter can also be turned into a boiler for distillation with the 3600W heating element (sold seperately). This element is 2inch Tri-Clover so it will fit directly into the port on the base of the Kegmenter.
From there you would need a 4" compatible still that is capable of running 3600w independently. (At this time KegLand does not stock such a beast)

Using the 2200W Weldless Heating Element
If you would like to use the AlcoEngine reflux still or pot still you will need to use the 2200w 10A weldless heating element that is stocked by KegLand and drill a 32mm hole for it through the wall of the Kegmenter. Then use a 10A Power Controller to adjust the wattage going to the still.
You will also need to reduce the 4" down to 2" to use the still. For this we recommend:
4 inch to 2 inch concentric reducer and a 2 inch tri-clover clamp allowing large washes to be distilled in a single run to save time.

Using as a Pressure Fermenter
Alternatively, this kegmenter can be used for pressure fermentation by swapping the flat lid for a kegmenter lid with ball lock posts and floating dip tube and attaching a BlowTie Spunding Valve for pressure control.

Download the Specification Sheet Here

Accessories shown in the images are sold seperately. This product includes the 118L Kegmenter itself, 4 inch flat lid, 4 inch tri-clover clamp and airlock.  

NOTE: Please be aware that this product is sent without carboard carton. It may arrive with some superficial scratches and small dents as the postal service can be rough with these.  The good thing is that they are made of thick stainless steel and can handle this type of treatment but they just might arrive with some cosmetic scratches and scuff marks.  This will not change the performance in any way.

 

 

 

Looking at a way to control fermentation temps while fermenting? Our RAPT fermentation chamber would be ideal for our kegmenter range. 

 

If you want to fit a thermowell to the lid of this fermenter then you should really check out this 60cm Stainless Thermowel that includes the bulkhead fitting so you can mount this into the lid of this Fermenter.